Inspection and analysis of automatic laminating machine before use

Automatic laminating machine before use to do a good job in the inspection and analysis work, timely find problems, to avoid mechanical equipment failure in operation. Next, we have a look at the full-automatic laminating machine before the use of what inspection work.

The full-automatic laminating machine is to regularly check whether there is rubber and oil dirt on the rubber roller, and wipe the glue mark and dust on the roller in time to ensure that the appearance of the two rollers is black. The surface of each roller of the automatic laminating machine should be cleaned. Not only that, it is necessary to clean the machine immediately after each use of the machine. Use the glue thinner to wash and wipe the rollers with soft towel. It is forbidden to scrape the surface of the roller with sharp tools. Clean the dust on the surface of each roller as usual when starting the machine. Computer gilding machine and check whether the surface of each roller of the machine is black. When the machine shows defects or abnormal dynamics, it is necessary to analyze and find out the reasons in time and eliminate them. Only when the machine is normal can it continue to operate.

The blade line of the full-automatic laminating machine should be flat and elastic. When the appearance of detour, mouth and curling edge appears, it should be repaired and exchanged in time. The blade of 0.15 ~ 0.20 mm manganese steel or offset press should be used to exchange according to the original standard. It is necessary to add lubricating oil to all transmission parts and sliding surfaces of the machine on time to ensure that the machine is in a lubricating state. Especially, the large bearing of the press in roll suffers from high pressure and high temperature, and the lubricating oil is evaporated at will. High temperature lubricating oil should be used in time, so that it can run normally under high temperature and high pressure. The full-automatic laminating machine floor formwork support uses the steel pipe bracket composed of connector and steel pipe, and gradually opens to fastener type steel pipe support.